honda — Cylinder Block/Crankshaft/Pistons

18) Apply engine oil to the threads and the seating face of the washer of the 11 x 95 mm bolt-washers. 19) Loosely tighten the ten 11 x 95 mm bolt-washers on the lower block, then tighten the bolt-washers in the numbered sequence in two or three steps to the specified torque. After tightening to the specified torque, tighten the bolt- washers to an additional 56˚ in the numbered order. ⑨ ⑩ TORQUE: 29 N . m (3.0 kgf . m, 22 lbf . ft) + 56˚ ⑥ ⑤ ① ② ④ ③ ⑧ ⑦ 20) Apply engine oil to the threads and seating face of both the 8 x 50 mm flange bolts and the 8 x 35 mm flange bolts. 21) Loosely tighten the four 8 x 50 mm flange bolts and ten 8 x 35 mm flange bolts on the lower block.

Tighten them to the specified torque in the numbered sequence in two or three steps. ⑬ ⑭ TORQUE: 26 N . m (2.7 kgf . m, 20 lbf . ft) ⑨ ⑩ ⑤ ⑥ ① ② ④ ③ ⑧ ⑦ ⑫ ⑪ 13-25