1. PROPELLER a. REMOVAL/INSTALLATION [1] 18 mm CASTLE NUT INSTALLATION: TORQUE: 1 N . m (0.1 kgf . m, 0.7 lbf . ft) If the split pin cannot be set by tightening to the specified torque, tighten the castle nut additionally until the split pin can be set. MAX. TORQUE: 44 N . m (4.5 kgf . m, 33 lbf . ft) [2] 3-BLADE PROPELLER [5] PROPELLER THRUST WASHER INSTALLATION: Install the propeller thrust washer as shown. [4] PROPELLER WASHER [3] 3 mm SPLIT PIN [5]-1 GEAR CASE SIDE [5]-2 PROPELLER SIDE INSTALLATION: • Replace with a new one on assembly. • Be sure to use the genuine part (stainless steel) and bend the pin ends as shown to stake the nut. [3]-1 3 mm SPLIT PIN 14-2