2. GEAR CASE ASSEMBLY [*1] [1] SPEED SENSOR TUBE B a. REMOVAL 1) Place the remote control lever in the “N” (Neutral) position. 2) Tilt up the outboard motor to the uppermost position. 3) Disconnect the speed sensor tube B and the speed sensor tube C. [2] SPEED SENSOR TUBE C 4) Remove the 10 x 32 mm hex. bolt and the 10 mm washer. Remove the trim tab from the gear case assembly. [1] TRIM TAB [3] 10 mm WASHER [2] 10 x 32 mm HEX. BOLT 5) Remove the seven 10 x 40 mm hex. bolts and the seven 10 mm washers, then remove the gear case assembly from the outboard motor. Remove the two dowel pins.
[1] 6 x 10 mm DOWEL PIN (2) 6) After removing the gear case assembly, lower the outboard motor to the lowermost position. [2] 10 mm WASHER (7) [4] GEAR CASE ASSEMBLY [3] 10 x 40 mm HEX. BOLT (7) 14-3