BF135A•BF150A • INTERMITTENT PROLONGED SOUND OF WARNING BUZZER KEEPS SOUNDING YES Perform MIL troubleshooting (P. 5-18 or 5-61). NO Check for open in the indicator light power line. 1 Turn the ignition switch OFF and disconnect the indicator light 3P connector. 2 Turn the ignition switch ON. Measure the voltage bet- ween the No. 3 (Yellow/Black) terminal of the harness side 3P connector and the engine ground. NO Replace or repair the wire har- ness (Open in the wire har- ness between the indicator light and No. 5 (10A) fuse). Harness side connector Viewing from terminal side Is there the battery voltage? Check for blown bulb. Replace if necessary.
If the bulb is not blown out, replace the indicator light. No Adjust the alternator belt ten- sion. NO Replace the fuse. Replace the fuse. NO Check the load. If there is no problem, replace the battery. NO 2-37 Is the MIL ON? N O Is the alternator indicator light ON? Y es Is the alternator belt tension correct? Y ES Is the alternator fuse (90A) nor- mal? Y ES Check the alternator 4P con- nector for connection. Is the alternator 4P connector connected properly? Y ES Measure the voltage between the measurement battery ter- minals. Is the voltage 13.5V or above? Y ES Perform alternator trouble- shooting (P. 2-31). Y es