3. WATER PUMP/SHIFT ROD [*1] [1] WATER TUBE SEAL RING [2] 8 x 40 mm HEX. BOLT (4) a. DISASSEMBLY Remove the following parts. – Propeller (P. 14-2) – Gear case assembly (P. 14-3) 1) Remove the speed sensor tube C. [8] IMPELLER HOUSING [3] 8 mm WASHER (4) [7] VERTICAL SHAFT 2) Remove the water tube seal ring from the impeller housing. 3) Remove the four 8 x 40 mm hex. bolts and the four 8 mm washers from the impeller housing. Remove the impeller housing. Remove the four distance collars from the impeller housing. [4] DISTANCE COLLAR (4) 4) Remove the woodruff key from the vertical shaft.
[5] WOODRUFF KEY [6] SPEED SENSOR TUBE C 5) Remove the impeller cover, impeller gasket, two dowel pins, gear case grommet and the rubber setting plate. [1] IMPELLER COVER Replace the impeller gasket with a new one on assembly. NOTICE [2] GEAR CASE GROMMET [5] IMPELLER GASKET [3] RUBBER SETTING PLATE [4] 6 x 10 mm DOWEL PIN (2) 14-7