honda — Propellor/Gear Case/Extension Case/Oil Case

8) Apply soapy water to the circumference of the 23 x 36 x 6 mm water seals. [1] 23 x 36 x 6 mm WATER SEALS [2] direction> 9) Drive the 23 x 36 x 6 mm water seals one by one in the water seal housing using the special tools. Note the installation direction of the water seals. Be sure to apply grease to the water seal mating surfaces before installation. TOOLS: Driver 07749-0010000 Attachment, 32 x 35 mm 07746-0010100 [3] (Apply grease to the water seal mating surfaces and the lips.) [4] DRIVER 07749-0010000 10) After installing the water seals, apply grease to the water seal lips.

[5] ATTACHMENT, 32 x 35 mm 07746-0010100 [6] WATER SEAL HOUSING 11) Apply grease to the circumference of the new 58.5 x 3.5 mm O-ring and position it on the water seal housing. [1] WATER SEAL HOUSING 6 x 20 12) Install the water seal housing so that the concave faces in the cruising direction, and tighten it with the two 6 x 20 mm flange bolts. [4] VERTICAL SHAFT [2] CONCAVE [3] 58.5 x 3.5 mm O-RING 14-14