13) Apply grease to the inner wall of the water pump liner. Install the pump impeller in the water pump liner with the woodruff key installation groove facing up and the pump impeller fins in the direction shown. Be sure to align the hole in the pump liner with the hole in the pump impeller. [1] (Apply grease to the inside.) [4] WATER PUMP LINER 14) Install the water pump liner in the impeller housing by aligning the two projections on the pump liner with the two grooves inside the impeller housing. Be sure that the part “A” of the water pump liner is in alignment with the part “B” of the impeller housing, too.
[2] PROJECTIONS [3] CONCAVES [1] “A” POINT 15) Apply grease to the circumference of the new water pump O-ring and install it on the impeller housing. [6] WATER PUMP LINER [5] IMPELLER HOUSING [4] “B” POINT 16) Install the rubber setting plate, gear case grommet, two dowel pins, new impeller gasket and the impeller cover. [2] IMPELLER COVER [1] IMPELLER GASKET [3] GEAR CASE GROMMET [5] 6 x 10 mm DOWEL PIN (2) [4] RUBBER SETTING PLATE 14-15 WOODRUFF KEY INSTALLATION GRO [3] PUMP IMPELLER [2] WOODRUFF KEY INSTALLATION GROOVE