7) Before removing the bearing, check the bearing for abnormal sound and play. Replace if necessary. 8) Install a commercially available universal bearing puller between the reverse bevel gear and the bearing. [1] DRIVER 07749-0010000 [2] ATTACHMENT, 27.2 07747-0010300 9) Remove the bearing from the reverse bevel gear using the special tools as shown. Replace the bearing with a new one on assembly. [5] UNIVERSAL BEARING PULLER (Commercially available) TOOLS: Driver 07749-0010000 Attachment, 27.2 07747-0010300 Pilot, 35 mm 07746-0040800 [3] 50 x 90 x 20 mm RADIAL BALL BEARING [4] PILOT, 35 mm 07746-0040800 10) Check the thrust bearing for abnormal sound and play. Replace if necessary.
[2] 105 x 3.1 mm O-RING [1] PROPELLER SHAFT HOLDER 11) Remove the thrust bearing, thrust bearing washer and the 105 x 3.1 mm O-ring from the propeller shaft holder. Replace the O-ring with a new one on assembly. [3] THRUST BEARING [4] THRUST BEARING WASHER 12) Before removing the 30 x 45 x 7 mm water seals, check the water seal lips for cut and other damage. Replace the water seals if necessary. [1] 30 x 45 x 7 mm WATER SEALS 13) Remove the two 30 x 45 x 7 mm water seals from the propeller shaft holder using a commercially available oil seal remover. Replace the water seals with the new ones on assembly. [2] PROPELLER SHAFT HOLDER 14-20