4) Remove the 3 x 12.8 mm roller from the shift slider assembly using a commercially available pin driver. [1] 3 x 12.8 mm ROLLER [2] SHIFT SLIDER ASSEMBLY 5) Remove the shift plate from the shift slider, then remove the two shift springs and the two #9 steel balls. [2] #9 STEEL BALLS NOTICE Take care not to let the shift springs and the #9 steel balls pop out of the shift slider during removal of the shift plate. [1] SHIFT SLIDER [3] SHIFT PLATE [4] SHIFT SPRINGS 6) Remove the reverse bevel gear/bearing assembly and the propeller shaft from the propeller shaft holder using the hydraulic press as shown.
[2] PROPELLER SHAFT [1] PROPELLER SHAFT HOLDER [3] HYDRAULIC PRESS TABLE [4] REVERSE BEVEL GEAR/BEARING ASSEMBLY 14-19