honda — Propellor/Gear Case/Extension Case/Oil Case

d. ASSEMBLY 1) Apply gear oil to the circumference of the new needle bearing. [1] ATTACHMENT, 62 x 68 mm 07746-0010500 [2] OUTER DRIVER ATTACHMENT, 30 x 37 070PD-ZY60200 2) Install the needle bearing on the propeller shaft holder using the special tools and the hydraulic press. TOOLS: Attachment, 62 x 68 mm 07746-0010500 Outer driver attachment, 30 x 37 070PD-ZY60200 NOTICE Install the needle bearing with the stamped side toward the special tools. [4] PROPELLER SHAFT HOLDER [3] 30 x 37 x 26 mm NEEDLE BEARING 3) Apply soapy water to the circumference of the new 30 x 45 x 7 mm water seals.

[1] 30 x 45 x 7 mm WATER SEALS [2] direction> 4) Drive the 30 x 45 x 7 mm water seals one by one into the propeller shaft holder using the special tool. Note the installation direction of the water seals. Apply grease to the water seal mating surfaces before installation. TOOL: Oil seal driver 07947-SB00100 [4] OIL SEAL DRIVER 07947-SB00100 [3] (Apply grease to the water seal mating surfaces and the lips.) 5) After installation of the water seals, apply grease to the water seal lips. 14-23 [5] PROPEL SHAFT LER HOLDE