6) Apply gear oil to the circumference of the new bearing. 7) Install the bearing on the revere bevel gear using the special tools and the hydraulic press. [1] DRIVER 07749-0010000 [2] ATTACHMENT, 62 x 68 mm 07746-0010500 TOOLS: Driver 07749-0010000 Attachment, 62 x 68 mm 07746-0010500 Pilot, 35 mm 07746-0040800 [5] REVERSE BEVEL GEAR [3] PILOT, 35 mm 07746-0040800 NOTICE Install the bearing holding the inner part of the bearing. [4] 50 x 90 x 20 mm RADIAL BALL BEARING 8) Apply gear oil to the circumference of the thrust bearing. 9) Soak the propeller shaft holder in the container filled with oil with the reverse bevel gear/bearing assembly installation side toward down.
10) Heat the oil to 80 – 90˚C (176 – 194˚F). 11) Check that there is no groove at the spline of the propeller installation side of the propeller shaft. [1] THERMOMETER [2] PROPELLER SHAFT HOLDER [3] Heat the oil to 80 – 90˚C (176 – 194˚F). [4] REVERSE BEVEL GEAR/BEARING ASSEMBLY 12) After the entire of the propeller shaft holder becomes hot, remove the holder from the container, and install the thrust bearing washer, thrust bearing, propeller shaft and the reverse bevel gear/bearing assembly in this order quickly on the propeller shaft holder. Note to install the thrust bearing water with the chamfered side toward the holder.
[5] PROPELLER SHAFT [8] THRUST BEARING [6] THRUST BEARING WASHER NOTICE Do not heat the oil above 90˚C (194˚F). The entire holder becomes hot. Be sure to wear the gloves during the operation. 13) Apply grease to the circumference of the new 105 x 3.1 mm O-ring and install it on the propeller shaft holder. [7] CHAMFER Wait until the propeller shaft holder cools down before installing the O-ring. NOTICE [2] PROPELLER SHAFT HOLDER 14-24 [1] [2] No groove [3] PROPELLER SHAFT [4] [5] Groove [3] PROPELLER SHAFT