honda — Propellor/Gear Case/Extension Case/Oil Case

14) Install the shift spring, two #9 steel balls, shift spring and the shift plate in this order in the shift slider. [2] 3 x 12.8 mm ROLLER [3] SHIFT SPRINGS 15) Install the 3 x 12.8 mm roller while aligning the hole in the shift slider with the hole in the shift plate, then install the 14 mm circlip. [1] SHIFT SLIDER [4] SHIFT PLATE [6] 14 mm CIRCLIP [5] #9 STEEL BALLS 16) Set the #7 steel balls in the steel ball installation holes in the shift slider assembly, then push the shift slider assembly slowly into the propeller shaft. [2] SHIFT SLIDER ASSEMBLY [1] PROPELLER SHAFT NOTICE Push the shift slider assembly into the propeller shaft with care not to allow the #7 steel balls to pop out.

[3] #7 STEEL BALL (2) 17) With the “F” mark on the clutch shifter toward the forward bevel gear (i.e. toward front), assemble the clutch shifter with the propeller shaft while aligning the 8 x 47 mm shifter pin installation hole with the long hole in the propeller shaft. [1] “F” MARK [2] REVERSE BEVEL [3] [7] PROPELLER SHAFT 14-25 GEAR SIDE RD BEVEL TER PIN ALLATION HOLE [5] LONG HOLE IN PROPELLER S CH SHIFTER [6] HAFT