honda — Propellor/Gear Case/Extension Case/Oil Case

6. VERTICAL SHAFT/BEVEL GEAR [*1] [1] VERTICAL SHAFT a. DISASSEMBLY Remove the following parts. – Propeller (P. 14-2) – Gear case assembly (P. 14-3) – Water pump/shift rod (P. 14-7) – Propeller shaft holder assembly (P. 14-17) 1) Attach the special tool to the end (crankshaft installation side) of the vertical shaft. [2] VERTICAL SHAFT HOLDER 07SPB-ZW10200 [3] PINION GEAR NUT TOOL: Vertical shaft holder 07SPB-ZW10200 2) Place a shop towel or equivalent material as shown to protect the gear case. 3) Holding the special tool, remove the pinion gear nut and the pinion gear. [5] GEAR CASE [4] SHOP TOWEL 4) Remove the 64 mm lock nut using the special tool as shown.

[1] LOCK NUT WRENCH, 30/64 mm 07916-MB00002 TOOL: Lock nut wrench, 30/64 mm 07916-MB00002 5) Remove the vertical shaft assembly. NOTICE Take care not to drop the needle bearing (roller) when removing the vertical shaft assembly. 6) Check the needle bearing for abnormal sound and play. If there is abnormal sound and play, replace the roller and the outer race as a set. [1] FORWARD BEVEL GEAR/TAPER BEARING ASSEMBLY 7) Remove the needle bearing (roller). 8) Check the taper bearing (inner race) of the forward bevel gear/taper bearing assembly for noise, play and other abnormality. Replace together with the outer race as a set if necessary.

[2] NEEDLE BEARING (ROLLER) 9) Remove the forward bevel gear/taper bearing assembly. 14-27