honda — Propellor/Gear Case/Extension Case/Oil Case

10) Check the taper bearing (outer race) for damage before removing it. Replace together with the inner race as a set if necessary. [3] FORWARD BEVEL GEAR SHIM [1] REMOVER WEIGHT 07741-0010201 [2] BEARING RACE PULLER 070PC-ZY3A100 11) Remove the taper bearing (outer race) using the special tools as shown. TOOLS: Remover weight 07741-0010201 Remover handle 07936-3710100 Bearing race puller 070PC-ZY3A100 12) Remove the forward bevel gear shim from the gear case. Replace the forward bevel gear shim with a new one on assembly.

[5] REMOVER HANDLE 07936-3710100 [4] 50 x 90 x 28 mm TAPER BEARING (OUTER RACE) 13) Remove the oil slinger from the vertical shaft by expanding the cut in the oil slinger with a screwdriver. [1] OIL SLINGER [2] VERTICAL SHAFT 14) Check the taper roller bearing for noise, play and other abnormality before removing it. Replace the inner race and the outer race as a set if necessary. [2] VERTICAL SHAFT 15) Set a commercially available universal bearing puller on the taper roller bearing (inner race), and install the vertical shaft on the hydraulic press with the crankshaft installation side toward up.

[1] 30 x 62 x 40 mm TAPER ROLLER BEARING [3] UNIVERSAL BEARING PULLER (Commercially available) 16) Remove the taper roller bearing from the vertical shaft using the hydraulic press. 17) Remove the pinion gear shim from the vertical shaft. Replace the pinion gear shim with a new one on assembly. 14-28