18) Check the needle bearing (outer race) in the gear case for damage before removing it. Replace the needle bearing (outer race) if necessary. 19) Attach the special tools to the needle bearing (outer race) and place a shop towel or equivalent material under the needle bearing (outer race) as shown. [1] DRIVER HANDLE, 15 x 280 mm 07949-3710001 [2] BEARING DRIVER ATTACHMENT, 37 mm 07ZMD-MBW0200 TOOLS: Driver handle, 15 x 280 mm 07949-3710001 Bearing driver attachment, 37 mm 07ZMD-MBW0200 Pilot, 35 mm 07746-0040800 20) Remove the needle bearing (outer race) from the gear case using the special tools.
NOTICE [6] NEEDLE BEARING (OUTER RACE) Remove the needle bearing (outer race) with care not to damage the gear case. Replace the needle bearing (outer race) and the roller as a set on assembly. [5] PILOT, 35 mm 07746-0040800 b. INSPECTION • VERTICAL SHAFT O.D. [1] AT NEEDLE BEARING 14-29 [3] GEAR CASE [4] SHOP TOWE STANDARD SERVICE LIMIT At needle bearing 28.556 – 28.575 mm (1.1242 – 1.1250 in) 28.545 mm (1.1238 in)