d. ASSEMBLY Measure the bearing height from the end of the taper bearing outer race to the end of the inner race and record the measurement before installing the 50 x 90 x 28 mm taper bearing on the forward bevel gear (P. 14-39). NOTICE [1] DRIVER 07749-0010000 [2] OIL SEAL DRIVER, 52 x 55 mm 07NAD-P200100 or 07NAD-P20A100 [3] FORWARD BEVEL GEAR 1) Apply gear oil to the inner wall and the roller of the new taper bearing (inner race). 2) Position a wood block or equivalent material underside the forward bevel gear. 3) Install the taper bearing on the forward bevel gear using the special tools and the hydraulic press. [5] 50 x 90 x 28 mm TAPER BEARING (INNER RACE) TOOLS:
Driver 07749-0010000 Oil seal driver, 52 x 55 mm 07NAD-P200100 or 07NAD-P20A100 [4] WOOD BLOCK 4) Install the new forward bevel gear shim in the gear case. [2] FORWARD BEVEL GEAR SHIM 5) Apply gear oil to the circumference of the taper bearing (outer race). [1] DRIVER HANDLE, 480 mm 070GD-0010100 6) Install the taper bearing (outer race) in the gear case using the special tools as shown. TOOLS: Driver handle, 480 mm 070GD-0010100 Taper vearing installer attachment 070PF-ZY60100 NOTICE Install the taper bearing (outer race) with the larger diameter side toward the forward bevel gear.
[3] 50 x 90 x 28 mm TAPER BEARING (OUTER RACE) [4] TAPER BEARING INSTALLER ATTACHMENT 070PF-ZY60100 7) Install the forward bevel gear/taper bearing assembly in the gear case. 8) Install the pinion gear on the vertical shaft and loosely tighten the pinion gear nut by hand. [2] VERTICALL SHAFT 9) Apply gear oil to the inner wall of the inner race, roller and the circumference of the outer race of the taper roller bearings. Assemble the inner races and outer race. [1] DRIVER SHAFT, B 07964-MB00200 10) Install the pinion gear shim, taper roller bearing and the special tool on the vertical shaft. TOOL: Driver shaft, B 07964-MB00200 [3] 30 x 62 x 40 mm TAPER ROLLER BEARING 14-31