honda — Propellor/Gear Case/Extension Case/Oil Case

11) Position the vertical shaft on the hydraulic press with the pinion gear side facing up. [2] PINION GEAR NUT 12) Install the taper roller bearing on the vertical shaft using the hydraulic press. [1] VERTICAL SHAFT [3] PINION GEAR Check that the ends of the special tool are set on the taper roller bearing inner race and on the hydraulic press table securely. Do not ruin the threads at the end of the vertical shaft (pinion gear nut installation part). NOTICE [8] 30 x 62 x 40 mm TAPER ROLLER BEARING [4] PINION GEAR SHIM 13) Remove the pinion gear nut and the pinion gear from the vertical shaft. [5] Set securely.

[7] DRIVER SHAFT, B 07964-MB00200 [6] HYDRAULIC PRESS TABLE 14) Install the oil slinger on the vertical shaft aligning the projection on the inside of the oil slinger with the concave of the pinion gear installation side of the vertical shaft. [2] PROJECTION [1] VERTICAL SHAFT [3] CONCAVE [4] OIL SLINGER 15) Attach the special tool to the new needle bearing as shown. Install the needle bearing with the stamped side of the needle bearing (outer race) toward the special tool. [2] NEEDLE BEARING [1] OIL SEAL DRIVER ATTACHMENT, 27.5 x 44 mm 07948-9540000 TOOL: Oil seal driver attachment, 27.5 x 44 mm 07948-9540000 14-32