16) Install the needle bearing in the gear case using the special tools. TOOLS: Shaft installer, 15 x 370 mm 07VMF-KZ30200 Attachment, 78 x 90 mm 07GAD-SD40101 Oil seal driver attachment, 27.5 x 44 mm 07948-9540000 [1] SHAFT INSTALLER, 15 x 370 mm 07VMF-KZ30200 [2] ATTACHMENT, 78 x 90 mm 07GAD-SD40101 17) After installation, check that the bottom surface of the needle bearing is flush with the bottom of the gear case. Apply grease to the needle bearing roller. [6] NEEDLE BEARING [5] (Apply grease to the roller.) [4] OIL SEAL DRIVER ATTACHMENT, 27.5 x 44 mm 07948-9540000 [3] GEAR CASE 18) Install the vertical shaft assembly taking care not to bring the needle bearing roller out of position.
[1] LOCK NUT WRENCH, 30/64 mm 07916-MB00002 19) Apply the thread locking agent to the threads and seat of the 64 mm lock nut, and tighten the lock nut using the special tool. TOOL: Lock nut wrench, 30/64 mm 07916-MB00002 TORQUE: 123 N . m (12.5 kgf . m, 90 lbf . ft) 14-33