20) Wipe the tapered part of the vertical shaft and pinion gear with a shop towel and a degreasing cleaning solvent. [1] VERTICAL SHAFT 21) Attach the special tool to the end (crankshaft installation side) of the vertical shaft as shown. TOOL: Vertical shaft holder 07SPB-ZW10200 22) Place a shop towel in the gear case as shown to protect the gear case. [2] VERTICAL SHAFT HOLDER 07SPB-ZW10200 [3] PINION GEAR NUT 23) Apply gear oil to the threads and seat of the pinion gear nut. 24) Install the pinion gear on the vertical shaft. Holding the special tool in the position, tighten the pinion gear nut to the specified torque. TORQUE: 142 N . m (14.5 kgf . m, 105 lbf .
ft) NOTICE Check that the forward bevel gear/taper bearing assembly is set properly. 25) Install the following parts. – Propeller shaft holder assembly (P. 14-17) – Water pump/shift rod (P. 14-12) – Gear case assembly (P. 14-5) – Propeller (P. 14-2) [5] GEAR CASE [4] SHOP TOWEL 14-34