honda — Propellor/Gear Case/Extension Case/Oil Case

7. SHIM SELECTION [*1] [1] PINION GEAR NUT [2] VERTICAL SHAFT Adjust the shim thickness after replacing the gear case, vertical shaft, bearing, taper bearing and the taper roller bearing. NOTICE a. PINION GEAR SHIM Remove the taper roller bearing if it is mounted on the vertical shaft (P. 14-28). 1) Wipe the tapered part of the vertical shaft and pinion gear with a shop towel and a degreasing cleaning solvent. 2) Install the pinion gear on the vertical shaft and tighten the pinion gear nut to the specified torque. [4] PINION GEAR [3] TAPERED PARTS TORQUE: 142 N . m (14.5 kgf . m, 105 lbf . ft) [2] TAPER ROLLER BEARING SIDE Do not install the vertical shaft in the gear case.

We recommend that you attach the special tool (vertical shaft holder) at the end of the vertical shaft to facilitate tightening of the pinion gear nut to the specified torque (P. 14-34). NOTICE [1] GAUGE ADAPTER, 110 mm 070PJ-ZY30100 3) Do not confuse the pinion gear side and the taper roller bearing side of the special tool. Do not score and scratch the opposite side (measurement side) from the side where the tool number is stamped. [3] PINION GEAR SIDE TOOL:

Gauge adapter, 110 mm 070PJ-ZY30100 [2] PINION GEAR [3] MEASUREMENT SURFACES 4) Holding the special tool with the side of the stamped tool number facing the opposite side from the pinion gear, be sure that the tool of the pinion gear nut side is not set on the nut. Tighten the bolts by hand while pushing both tools toward the pinion gear side. [1] Tool must not get on the nut. Do not tighten the bolts with a tool. There must be no wobbling in the special tool. It must securely set on the pinion gear. NOTICE [6] BOLT (2) [5] PINION GEAR NUT [4] TOOL NO.

STAMPED SURFACE 5) Set both tools on both sides of the flange of the vertical shaft with the side of the special tool stamped with the tool number and the tapered part facing the opposite side from the pinion gear as shown. Tighten the bolts by hand. [1] MEASUREMENT SURFACE NOTICE [2] TOOL NO. STAMPED SURFACE Do not tighten the bolts with a tool. There must be no wobbling in the special tool. It must securely set on the pinion gear. [3] TAPERED SURFACE [4] BOLTS 14-35