c. INSTALLATION 1) Place the remote control lever in the “N” (Neutral) position. [1] CUTOUT 2) Check that the shift rod of the gear case is in the “N” (Neutral) position. To check: Check whether the cutout of the shift rod spline faces in the direction shown. [It indicates that the shift rod is in the “N” (Neutral) position.] [3] SHIFT ROD [2] CRUISING DIRECTION 3) If the cutout of the spline is not in the direction shown, protect the spline with a shop towel or equivalent material and turn the shift rod right and left with a wrench until the cutout faces toward the specified direction. [2] SHIFT ROD [1] SHOP TOWEL 4) Tilt up the outboard motor to the uppermost position.
5) Apply grease to the spline of the shift rod A. 6) Install the shift rod A by aligning the projection of the shift shaft A with the cutout in the spline of the shift rod A. Check that the cutout in the spline of the shift rod A is toward the cruising direction. [3] CUTOUT [1] SHIFT SHAFT A [2] PROJECTION [4] CRUISING DIRECTION [4] CRUISING DIRECTION [5] SHIFT ROD A 14-44