6) Apply gear oil to the circumference of the new 105 x 3.1 mm O-ring and install it on the propeller shaft holder. 7) Install the new thrust shim on the propeller shaft holder. [2] THRUST BEARING 8) Install the thrust bearing washer with the chamfered side toward the thrust shim. [1] CHAMFER [6] THRUST SHIM [3] THRUST BEARING WASHER 9) Apply gear oil to the circumference of the thrust bearing and install it on the thrust bearing washer. [5] 105 x 3.1 mm O-RING 10) Check that there is the groove at the spline of the propeller installation side of the propeller shaft.
[4] PROPELLER SHAFT HOLDER [2] THRUST BEARING WASHER [1] PROPELLER SHAFT HOLDER 11) Install the propeller shaft and the thrust bearing washer on the propeller shaft holder. Install the thrust bearing washer with the chamfered side toward the flange of the propeller shaft. [3] CHAMFER [4] PROPELLER SHAFT 12) Install the new shim on the bearing holder. 13) Apply gear oil to the circumference of the taper bearing (outer race) and install it on the bearing holder. [1] FORWARD BEVEL GEAR SHIM NOTICE [3] BEARING HOLDER [2] 50 x 90 x 28 mm TAPER BEARING (OUTER RACE) Install the taper bearing (outer race) with the smaller diameter side toward the shim.
14) Install the taper bearing (outer race) on the bearing holder using the special tools and the hydraulic press as shown. TOOLS: Driver 07749-0010000 Taper bearing inataller attachment 070PF-ZY60100 [1] DRIVER 07749-0010000 [2] TAPER BEARING INSTALLER ATTACHMENT 070PF-ZY60100 [4] 50 x 90 x 28 mm TAPER BEARING (OUTER RACE) [3] BEARING HOLDER 14-64 [1] [2] No groove [3] PROPELLER SHAFT [4] [5] Groove [3] PROPELLER SHAFT