15) Place the wood block under the forward bevel geaar. 16) Place the bearing holder assembly on the forward bevel gear. [2] ATTACHMENT, 62 x 68 mm 07746-0010500 17) Apply gear oil to the inner wall of the taper bearing inner race and position it in the forward bevel gear. [1] DRIVER 07749-0010000 18) Install the taper bearing inner race on the forward bevel gear using the special tools and hydraulic press. TOOLS: Driver 07749-0010000 Attachment, 62 x 68 mm 07746-0010500 [6] 50 x 90 x 28 mm TAPER BEARING (INNER RACE) Install by applying gear oil between the inner and outer races of the taper bearing.
NOTICE [5] BEARING HOLDER ASSEMBLY [4] FORWARD BEVEL GEAR [3] WOOD BLOCK 19) Apply gear oil to the threads and seat of the bearing holder assembly. 20) Position the bearing holder assembly on the propeller shaft. Loosely tighten the bearing holder assembly by hands against the propeller shaft holder. [1] BEARING HOLDER ASSEMBLY [2] PIN SPANNER WRENCH, 110 mm 07WAA-S1G0100 21) Attach the fixing tool, that had been used during propeller shaft/propeller shaft holder removal, on the propeller shaft holder assembly and secure with the bolt. 22) Tighten the bearing holder to the specified torque using the special tool as shown. TOOL: Pin spanner wrench, 110 mm 07WAA-S1G0100 TORQUE: 191 N .
m (19.5 kgf . m, 141 lbf . ft) NOTICE Avoid holding the propeller shaft holder directly in a vise. Use the fixing tool to hold it in a vise. [3] PROPELLER SHAFT HOLDER ASSEMBLY [4] FIXING TOOL 14-65