honda — Propellor/Gear Case/Extension Case/Oil Case

23) Install the shift spring, two #9 steel balls, shift spring and the shift plate in this order in the shift slider. [2] 3 x 12.8 mm ROLLER [3] SHIFT SPRINGS 24) Install the 3 x 12.8 mm roller aligning the hole in the shift slider with the hole in the shift plate, then install the 14 mm circlip. [1] SHIFT SLIDER [4] SHIFT PLATE [6] 14 mm CIRCLIP [5] #9 STEEL BALLS 25) Set the #7 steel balls in the steel ball installation holes in the shift slider assembly, and push the shift slider assembly slowly into the propeller shaft. [2] SHIFT SLIDER ASSEMBLY [1] PROPELLER SHAFT NOTICE Push the shift slider assembly into the propeller shaft with care not to allow the #7 steel balls to pop out.

[3] #7 STEEL BALL (2) 26) With the “F” mark on the clutch shifter toward the reverse bevel gear (i.e. toward front), assemble the clutch shifter with the propeller shaft while aligning the 8 x 47 mm shifter pin installation hole with the long hole in the propeller shaft. [1] “F” MARK [2] FORWARD BEVEL GEAR SIDE [3] REVERSE BEVEL GEAR SIDE [4] SHIFTER PIN INSTALLATION HOLE [5] LONG HOLE IN PROPELLER SHAFT [7] CLUTCH SHIFTER [6] PROPELLER SHAFT 14-66