honda — Propellor/Gear Case/Extension Case/Oil Case

27) Install the 8 x 47 mm shifter pin while aligning the hole in the clutch shifter with the hole in the shift slider. [2] 8 x 47 mm SHIFTER PIN [1] HOLE IN SHIFT SLIDER [3] SHIFT SLIDER [5] HOLE IN CLUTCH SHIFTER [4] CLUTCH SHIFTER 28) Install the cross pin ring on the clutch shifter. Check that the coils of the cross pin ring do not overlap each other. NOTICE [2] CROSS PIN RING [1] CLUTCH SHIFTER 29) Check that the #7 steel balls are set in the groove in the propeller shaft securely as shown. [1] CLUTCH SHIFTER [3] PROPELLER SHAFT [2] GROOVE Check procedure: Be sure that the clutch shifter is not at the forward bevel gear installation side.

If it is at the forward bevel gear installation side, pull up the shift slider assembly slowly. Be sure that the #7 steel balls cannot be checked through the gap between the propeller shaft and shift slider. If the steel balls can be checked, push in the shift slider assembly slowly again. 30) Install the following parts. – Propeller shaft holder assembly (P. 14-56) – Water pump/shift rod (P. 14-51) – Gear case assembly (P. 14-44) – Propeller (P. 14-2) [4] SHIFT SLIDER [5] #7 STEEL BALL (2) 14-67