honda — Propellor/Gear Case/Extension Case/Oil Case

14. VERTICAL SHAFT/BEVEL GEAR [*2] [1] VERTICAL SHAFT a. DISASSEMBLY Remove the following pars. – Propeller (P. 14-2) – Gear case assembly (P. 14-42) – Water pump/shift rod (P. 14-46) – Propeller shaft holder assembly (P. 14-56) 1) Attach the special tool to the end (crankshaft installation side) of the vertical shaft. TOOL: Vertical shaft holder 07SPB-ZW10200 [2] VERTICAL SHAFT HOLDER 07SPB-ZW10200 2) Place a shop towel or equivalent material as shown to protect the gear case. [3] PINION GEAR NUT 3) Holding the special tool, remove the pinion gear nut and the pinion gear. [5] GEAR CASE [4] SHOP TOWEL 4) Remove the 64 mm lock nut using the special tool as shown.

[1] LOCK NUT WRENCH, 30/64 mm 07916-MB00002 TOOL: Lock nut wrench, 30/64 mm 07916-MB00002 5) Remove the vertical shaft assembly. NOTICE Take care not to drop the needle bearing (roller) when removing the vertical shaft assembly. 14-68