10) Check the bearing for abnormal noise and play before removal. Replace if necessary. [3] 50 x 90 x 20 mm RADIAL BALL BEARING 11) Remove the 50 x 90 x 20 mm radial ball bearing using the special tools as shown. [1] REMOVER WEIGHT 07741-0010201 [2] BEARING RACE PULLER 070PC-ZY3A100 TOOLS: Remover weight 07741-0010201 Remover handle 07936-3710100 Bearing race puller 070PC-ZY3A100 Puller jaws, 25 mm 07WPC-ZW50100 12) Remove the reverse bevel gear shim from the gear case. NOTICE [6] REMOVER HANDLE 07936-3710100 [5] PULLER JAWS, 25 mm 07WPC-ZW50100 [4] REVERSE BEVEL GEAR SHIM Replace the 50 x 90 x 20 mm radial ball bearing with a new one on assembly.
Replace the reverse bevel gear shim on assembly. 13) Remove the oil slinger from the vertical shaft expanding the cut in the oil slinger using a screwdriver. [1] OIL SLINGER [2] VERTICAL SHAFT 14) Check the taper roller bearing for noise, play and other abnormality before removing it. Replace the inner race and the outer race as a set if necessary. [2] VERTICAL SHAFT 15) Position a commercially available universal bearing puller on the taper roller bearing (inner race), and position the vertical shaft on the hydraulic press with the crankshaft installation side toward up.
[1] 30 x 62 x 40 mm TAPER ROLLER BEARING [3] UNIVERSAL BEARING PULLER (Commercially available) 16) Remove the taper roller bearing from the vertical shaft using the hydraulic press. 17) Remove the shim from the vertical shaft. Replace the shim with a new one on assembly. 14-70