honda — Propellor/Gear Case/Extension Case/Oil Case

18) Check the needle bearing (outer race) for damage before removal. Replace if necessary. 19) Position the special tools on the needle bearing (outer race) and the shop towel under the needle bearing (outer race) as shown. [1] DRIVER HANDLE, 15 x 280 mm 07949-3710001 [2] BEARING DRIVER ATTACHMENT, 37 mm 07ZMD-MBW0200 TOOLS: Driver handle, 15 x 280 mm 07949-3710001 Bearing driver attachment, 37 mm 07ZMD-MBW0200 Pilot, 35 mm 07746-0040800 20) Remove the needle bearing (outer race) from the gear case using the special tools. Remove the needle bearing (outer race) with care not to damage the gear case. Replace the needle bearing (outer race) and the roller as a set on assembly.

NOTICE [6] NEEDLE BEARING (OUTER RACE) [5] PILOT, 35 mm 07746-0040800 [3] GEAR CASE [4] SHOP TOWEL b. INSPECTION • VERTICAL SHAFT O.D. [1] AT NEEDLE BEARING 14-71 STANDARD SERVICE LIMIT At needle bearing 28.556 – 28.575 mm (1.1242 – 1.1250 in) 28.545 mm (1.1238 in)