honda — Propellor/Gear Case/Extension Case/Oil Case

d. ASSEMBLY 1) Apply gear oil to the circumference of the new bearing. 2) Place a wood block under the reverse bevel gear. [1] OIL SEAL DRIVER, 65 mm 07JAD-PL90100 or 07JAD-PL9A100 [2] 50 x 90 x 20 mm RADIAL BALL BEARING 3) Install the bearing on the reverse bevel gear using the special tool and the hydraulic press. TOOL: Oil seal driver, 65 mm 07JAD-PL90100 or 07JAD-PL9A100 [4] REVERSE BEVEL GEAR [3] WOOD BLOCK 4) Soak the gear case in the container filled with oil with the bearing installation side toward down. [1] THEMOMETER [2] GEAR CASE 5) Heat the oil to 80 – 90˚C (176 – 194˚F).

6) After the entire of the bearing installation side of the gear case becomes hot, remove the gear case from the container and install the bevel gear shim and the reverse bevel gear/bearing assembly on the gear case quickly. NOTICE Do not heat the oil above 90˚C (194˚F). The entire gear case becomes hot. Be sure to wear the gloves during the operation. Do not apply the force of 8,829 N (900 kgf, 1984 lbf) or above during installation. [3] Heat the oil to 80 – 90˚C (176 – 194˚F). [5] REVERSE BEVEL GEAR/BEARING ASSEMBLY [4] REVERSE BEVEL GEAR SHIM [6] GEAR CASE 14-73