7) Position the pinion gear on the vertical shaft and loosely tighten the pinion gear nut by hand. 8) Apply gear oil to the inner wall of the inner race, roller and the circumference of the outer race of the taper roller bearings. Assemble the inner race and the outer race. [2] VERTICAL SHAFT 9) Position the shim, taper roller bearing and the special tool on the vertical shaft. [1] DRIVER SHAFT, B 07964-MB00200 TOOL: Driver shaft, B 07964-MB00200 [3] 30 x 62 x 40 mm TAPER ROLLER BEARING 10) Position the vertical shaft on the hydraulic press with the pinion gear toward up as shown. [2] PINION GEAR NUT 11) Install the taper roller bearing on the vertical shaft using the hydraulic press.
NOTICE [1] VERTICAL SHAFT [3] PINION GEAR Check that the ends of the special tool are set on the taper roller bearing inner race and the hydraulic press table securely. Do not ruin the threads at the end of the vertical shaft (pinion gear nut installation part). [4] PINION GEAR SHIM [8] 30 x 62 x 40 mm TAPER ROLLER BEARING 12) Remove the pinion gear nut and the pinion gear from the vertical shaft. [5] Set securely. [7] DRIVER SHAFT, B 07964-MB00200 [6] HYDRAULIC PRESS TABLE 14-74