13) Install the oil slinger on the vertical shaft aligning the projection on the inside of the oil slinger with the recess of the pinion gear installation side of the vertical shaft. [1] VERTICAL SHAFT [2] PROJECTION [3] CONCAVE [4] OIL SLINGER 14) Attach the special tool to the new needle bearing as shown. Install the needle bearing with the stamped side of the needle bearing (outer race) toward the special tool. [2] NEEDLE BEARING TOOL: Oil seal driver attachment, 27.5 x 44 mm 07948-9540000 [1] OIL SEAL DRIVER ATTACHMENT, 27.5 x 44 mm 07948-9540000 15) Install the needle bearing in the gear case using the special tools.
[1] SHAFT INSTALLER, 15 x 370 mm 07VMF-KZ30200 [2] ATTACHMENT, 78 x 90 mm 07GAD-SD40101 TOOLS: Shaft installer, 15 x 370 mm 07VMF-KZ30200 Attachment, 78 x 90 mm 07GAD-SD40101 Oil seal driver attachment, 27.5 x 44 mm 07948-9540000 16) After installation, check that the bottom surface of the needle bearing is flush with the bottom of the gear case. Apply grease to the needle bearing roller. [6] (Apply grease to the roller.) [5] NEEDLE BEARING [4] OIL SEAL DRIVER ATTACHMENT, 27.5 x 44 mm 07948-9540000 [3] GEAR CASE 14-75