17) Install the vertical shaft assembly with care not to let the needle bearing roller come out of position. 18) Apply gear oil to the threads and seat of the 64 mm lock nut, and tighten the lock nut using the special tool. [1] LOCK NUT WRENCH, 30/64 mm 07916-MB00002 TOOL: Lock nut wrench, 30/64 mm 07916-MB00002 TORQUE: 123 N . m (12.5 kgf . m, 90 lbf . ft) 19) Wipe the tapered part of the vertical shaft and pinion gear with a shop towel and a degreasing cleaning solvent. [1] VERTICAL SHAFT 20) Attach the special tool to the end (crankshaft installation side) of the vertical shaft as shown. TOOL:
Vertical shaft holder 07SPB-ZW10200 21) Place a shop towel in the gear case as shown to protect the gear case. [2] VERTICAL SHAFT HOLDER 07SPB-ZW10200 22) Apply gear oil to the threads and seat of the pinion gear nut. [3] PINION GEAR NUT 23) Tighten the pinion gear nut to the specified torque while installing the pinion gear on the vertical shaft and holding the special tool in position. TORQUE: 142 N . m (14.5 kgf . m, 105 lbf . ft) NOTICE Check that the forward bevel gear/taper bearing assembly is set properly. 24) Install the following parts. – Propeller shaft holder assembly (P. 14-56) – Water pump/shift rod (P. 14-51) – Gear case assembly (P. 14-44) – Propeller (P.
14-2) [5] GEAR CASE [4] SHOP TOWEL 14-76