honda — Propellor/Gear Case/Extension Case/Oil Case

c. ASSEMBLY 1) Apply grease to the circumference of the water tube grommet and install it on the water tube. 2) Connect the water tube to the oil case noting the installation direction as shown. [1] PROJECTION 3) Install the water tube set plate aligning the stopper hole of the water tube set plate with the projection on the oil case, and then tighten the 6 x 12 mm flange bolt. [2] STOPPER HOLE [5] WATER TUBE GROMMET [3] WATER TUBE SETTING PLATE 6 x 12 [4] WATER TUBE 4) Install the under cover seal B, extension case grommet and the two dowel pins on the extension case.

[1] EXTENSION CASE GROMMET [2] UNDER COVER SEAL B NOTICE Install the under cover seal B underside the projections of the extension case securely. 5) Apply grease to the inner wall of the vertical shaft bushing. Install the vertical shaft bushing, 26 mm washer and the circlip in the extension case (XC, XCC, XD and XCD types only). [3] 6 x 10 mm DOWEL PIN (2) [1] XC, XCC, XD and XCD types only [2] EXTENSION CASE [3] VERTICAL SHAFT BUSHING [4] EXTENSION CASE [4] 26 mmWASHER [5] CIRCLIP [5] PROJECTION [2] UNDER COVER SEAL B 14-91