honda — Propellor/Gear Case/Extension Case/Oil Case

5) Apply the engine oil to the threads and seat of the sixteen 10 x 40 mm flange bolts. Install the two dowel pins and the oil case on the mount case, then loosely tighten the sixteen 10 x 40 mm flange bolts. [2] OIL LEVEL GAUGE [1] OIL LEVEL PIPE 6 x 12 6) Apply engine oil to the new 11.5 x 3.5 mm O-ring, and install it on the oil level pipe. 7) Install the oil level pipe on the mount case and tighten the 6 x 12 mm flange bolts. Install the oil level gauge. [3] 11.5 x 3.5 mm O-RING [4] 6 x 10 mm DOWEL PIN (2) [5] OIL CASE 10 x 40 (16) 8) Tighten the 10 x 40 mm flange bolts to the specified torque in the numbered sequence in two or three steps. TORQUE: 34 N . m (3.5 kgf . m, 25 lbf .

ft) ⑫ ⑥ 9) Tighten the 12 mm drain plug washer and the oil drain plug bolt on the oil case. Tighten them to the specified torque and add the engine oil. ⑪ ⑬ TORQUE: 23 N . m (2.3 kgf . m, 17 lbf . ft) ⑩ ④ ⑤ ① ⑭ 10) Install the following parts. – Extension case/lower rubber mount (P. 14-91) – Gear case assembly (P. 14-5 and 44) – L./R. engine under cover (P. 4-14) – Engine cover (P. 4-2) ② ⑨ ⑮ ⑧ ③ ⑦ ⑯ 14-96