honda — Propellor/Gear Case/Extension Case/Oil Case

b. INSTALLATION 1) Clean the oil case and mount case mating surfaces and the both sides of the oil pan gasket with a cleaning solvent and a shop towel. 2) Apply bead [ш1.0 – 5.0 mm (ш0.04 – 0.20 in)] of the liquid gasket (ThreeBond ® #1211 or equivalent) to the indicated area of the oil pan gasket. [1] Liquid gasket application area [2] OIL PAN GASKET NOTICE Assemble within 90 minutes after application of the liquid gasket. If the parts have been left unassembled for 90 minutes, remove the old gasket and apply a new gasket again. Do not fill in the oil case with the engine oil for 15 minutes after assembly.

[3] LIQUID GASKET (Apply to both sides.) [4] OIL PAN GASKE 3) Apply engine oil to the circumference of the new 20.6 x 2.6 mm O-ring, and install it on the oil strainer. [1] MOUNT CASE 4) Install the oil pan gasket on the mount case. Install the oil strainer and tighten the two 6 x 18 mm flange bolts. [4] OIL PAN GASKET 6 x 8 (2) [3] OIL STRAINER 14-95 [2] 20.6 x O-RIN 2.6 mm G