honda — Propellor/Gear Case/Extension Case/Oil Case

20. OIL CASE a. REMOVAL Remove the following parts. – Engine cover (P. 4-2) – L./R. engine under cover (P. 4-9) – Gear case assembly (P. 14-3 and 42) – Extension case/lower rubber mount (P. 14-89) 1) Drain the engine oil from the oil case (P. 3-2). 2) Remove the sixteen 10 x 40 mm flange bolts and remove the oil case from the mount case. [1] OIL LEVEL PIPE 6 x 12 [2] OIL LEVEL GAUGE [10] OIL PAN GASKET [3] 11.5 x 3.5 mm O-RING Do not reuse. [4] 6 x 10 mm DOWEL PIN (2) [5] 20.6 x 2.6 mm O-RING Do not reuse. 6 x 18 (2) [9] OIL CASE [6] OIL STRAINER [7] OIL DRAIN PLUG BOLT 23 N . m (2.3 kgf . m, 17 lbf . ft) [8] 12 mm DRAIN PLUG WASHER Do not reuse. 10 x 40 (16) 34 N . m (3.5 kgf . m, 25 lbf .

ft) 14-94