honda — Propellor/Gear Case/Extension Case/Oil Case

10) Install the lower mount collar and the lower rubber mount on the extension case. NOTICE [1] 12 x 225 mm HEX. BOLT Install the lower mount collar with the smaller diameter side toward the lower rubber mount. Install the lower rubber mount with the “OUT” mark toward out. 11) Install the 12 x 225 mm hex. bolt, two 12 mm washers and the 12 mm self-locking nut. Holding the 12 mm self-locking nut with a wrench, tighten the 12 x 225 mm hex. bolt to the specified torque. TORQUE: 83 N . m (8.5 kgf . m, 61 lbf . ft) [6] LOWER MOUNT COLLAR [5] “OUT” MARK [2] 12 mm SELF- LOCKING NUT [4] LOWER RUBBER MOUNT [3] 12 mm WASHER (2) 12) Connect the ground cable with the 6 x 12 mm flange bolt.

13) Install the lower mount housing on the extension case, and tighten the three 8 mm washers and the three 8 x 30 mm hex. bolts. [1] LOWR MOUNT HOUSING 14) Remove the hoist hooks from the engine hangers and lower the outboard motor to the lowermost position. 6 x 12 15) Install the following pars. – Gear case assembly (P. 14-5 and 44) – L./R. engine under cover (P. 4-14) – Engine cover (P. 4-2) [2] GROUND CABLE [4] 8 x 30 mm HEX. BOLT (3) [3] 8 mm WASHER (3) 14-93