honda — Power Trim/Tilt Assembly

b. MOUNTING CASE DISASSEMBLY 1) Remove the under cover seal A and the mounting case rubber seal from the mounting case. Remove the shift shaft B and the shift shaft washer. 2) Remove the three 6 x 25 mm flange bolts and remove the idle exhaust port and the idle exhaust port gasket. Replace the gasket with a new one on assembly. 3) Check the 22 x 35 x 7 mm water seal lips for cut and replace if necessary before removal. Remove the two 22 x 35 x 7 mm water seals using a commercially available oil seal remover. Replace the oil seals with the new ones on assembly. 4) Remove the 12 mm E-ring from the shift shaft A and remove the 14 mm washer and the shift shaft A.

Check the 14 x 26 x 8 mm water seal lip for cut and replace if necessary before removal. Remove the 14 x 26 x 8 mm water seal using a commercially available oil seal remover. Replace with a new one on assembly. 5) Remove the two 12 x 145 mm stud bolts from the upper rubber mount. 6) Remove the six 8 x 35 mm flange bolts and remove the upper mount holder, upper mount holder gasket and the upper rubber mount. Replace the gasket with a new one on assembly. Check the upper rubber mount for deterioration and cracks. Replace with a new one if necessary.

15-3 [5] 22 x 35 x 7 mm 8 x 35 WATER SEAL (2) 4] SHIFT SHAFT B [6] UP HO [7] UP T A HO [8] U m M NG 6 [1 [ [13] [9] IDLE EXHAUST PORT 0] IDLE EXHAUST PORT GASKET [11] MOUNTING CASE [16] 14 mm WASHER [15] 12 mm E-RING 12] UNDER COVER SEAL A [14] 12 x 145 mm STUD BOLT (2) 13] 8 x 35 (6) [6] UP HO PER MOUNT LDER [7] UP HO PER MOUNT LDER GASKET [3] SHIFT SHAF T A [8] U M PPER RUBBER OUNT [2] 20 x 28 x 13 m NEEDLE BEARI m NG [17] 14 x 26 x 8 mm WATER SEAL