honda — Power Trim/Tilt Assembly

c. 20 x 28 x 13 mm NEEDLE BEARING REMOVAL [1] 20 x 28 x 13 mm NEEDLE BEARING 1) Remove all parts from the mounting case. 2) Warm up the 20 x 28 x 13 mm needle bearing of the mounting case and remove the needle bearing. Replace the 20 x 28 x 13 mm needle bearing with a new one on assembly. NOTICE Take care not to get burned during operation. [2] MOUNTING CASE d. 20 x 28 x 13 mm NEEDLE BEARING INSTALLATION 1) Apply engine oil to the circumference of the new 20 x 28 x 13 mm needle bearing. [1] DRIVER 07749-0010000 2) Install the 20 x 28 x 13 mm needle bearing in the mounting case using the special tools and the hydraulic press as shown. [2] ATTACHMENT, 28 x 30 mm 07946-1870100 TOOLS:

Driver 07749-0010000 Attachment, 28 x 30 mm 07946-1870100 Pilot, 20 mm 07746-0040500 [3] PILOT, 20 mm 07746-0040500 e. MOUNTING CASE ASSEMBLY [2] “UP” MARK [1] UPPER RUBBER MOUNT 1) Install the upper rubber mount in the mounting case with the “UP” mark on the upper rubber mount toward up and the white paint mark toward the opposite side from the water seal installation part. [3] WHITE PAINT MARK Note the installation direction of the upper rubber mount. [4] WATER SEAL INSTALLATION PART 15-4