honda — Power Trim/Tilt Assembly

2) Install the new upper mount holder gasket and the upper mount holder on the upper rubber mount with the cutouts in the upper mount holder gasket and in the upper mount holder toward the opposite side from the water seal installation part. 8 x 35 (6) [1] UPPER MOUNT HOLDER Note the installation direction. 3) Tighten the upper rubber mount securely with the six 8 x 35 mm flange bolts. [4] WATER SEAL INSTALLATION PART [2] CUTOUTS [3] UPPER MOUNT HOLDER GASKET 4) Tighten the two 12 x 145 mm stud bolts on the upper rubber mount securely with the longer threads of the stud bolts toward the upper rubber mount side.

[1] UPPER RUBBER MOUNT [2] 12 x 145 mm STUD BOLT (2) [3] [5] LONG [4] SHORT [6] UPPER RUBBER MOUNT SIDE 15-5