15) Clean the mounting case/idle exhaust port mating surfaces and the both sides of the idle exhaust port gasket thoroughly with a degreasing cleaning solvent and shop towel. [2] LIQUID GASKET (Apply to both sides.) [1] LIQUID GASKET APPLICATION AREA 16) Apply a bead [ш1.0 – 5.0 mm (ш0.04 –0.20 in)] of the liquid gasket (ThreeBond ® #1211 or equivalent) to the indicated area of the both sides of the idle exhaust port gasket. NOTICE [3] GASKET Install the idle exhaust gasket within 90 minutes after application of the liquid gasket. [4] IDLE EXHAUST PORT GASKET If it has been left for 90 minutes or longer, remove the old gasket and apply a liquid gasket again before installation.
17) Install the idle exhaust port gasket on the mounting case and tighten the three 6 x 25 mm flange bolts securely. 6 x 25 (3) [5] IDLE EXHAUST PORT [4] IDLE EXHAUST PORT GASKET 18) Install the mounting case rubber seal on the mounting case with the cut side to your side. 19) Install the under cover seal A on the mounting case (P. 15- 3). [1] MOUNTING CASE RUBBER SEAL [2] Install with the cut side to your side. 15-8