honda — Power Trim/Tilt Assembly

2. STERN BRACKET/SWIVEL CASE REMOVAL/INSTALLATION [1] POWER TILT MOTOR 2P CONNECTOR [2] TRIM ANGLE SENSOR 3P CONNECTOR a. REMOVAL Remove the following parts. – Engine cover (P. 4-2) – L./R. engine under covers (P. 4-9) – Gear case assembly (P. 14-3 and 42) – Remote control cable/grommet (P. 17-2) – Starter cable (P. 18-15) 1) Place the outboard on a level surface (i.e. outboard motor in the vertical position). 2) Remove the trim angle sensor 3P connector and the power tilt motor 2P connector from the connector bracket A. [3] CONNECTOR BRACKET A Disconnect the trim angle sensor 3P connector and the power tilt motor 2P connector.

3) Remove the undercase grommet C outside the under cover front bracket. [1] UNDER COVER FRONT BRACKET [2] WIRES [3] TUBE Pull off the tube and wires through the hole in the under cover front bracket. [5] HOLE [4] UNDERCASE GROMMET C 4) Hook the hoist hook on each of the three engine hangers. [2] HOIST CHAIN Remove the following part. – Lower rubber mount (P. 14-89) NOTICE [3] ENGINE HANGER (2) [1] ENGINE HANGER B Check that the outboard motor is not lifted off. 15-10