honda — Power Trim/Tilt Assembly

5) Swing the outboard motor right and left and remove the two 12 mm self-locking nuts. 6) Check that the engine assembly/mounting case mating surfaces are level to the ground. Holding the outboard motor with the hoist, remove the stern bracket/swivel case assembly mounted on the outboard motor stand from the outboard motor. If it is hard to remove the stern bracket/swivel case assembly, remove by raising and lowering the outboard motor slowly with the hoist. NOTICE Do not raise the outboard motor stand off the ground while raising the outboard motor with the hoist.

[1] 12 mm SELF- LOCKING NUT Remove the stern bracket/swivel case assembly with care not to damage the threads of the two 12 x 145 mm stud bolts. 7) After removing the stern bracket/swivel case assembly, lower the outboard motor slowly. Store the outboard motor with the extension case set on the ground. NOTICE If it is necessary to store the outboard motor by laying it on its side, install the L./R. engine under covers (P. 4-14), drain the engine oil (P. 3-2) and drain the gasoline from the vapor separator. [1] 12 mm SELF- LOCKING NUT Then, lay the outboard motor on a urethane foam sheet or blanket with the intake manifold toward down.

[1] 12 mm SELF-LOCKING NUT (2) [2] STERN BRACKET/SWIVEL CASE ASSEMBLY 15-11