honda — Power Trim/Tilt Assembly

b. INSTALLATION 1) Lift up the outboard motor until the 12 x 145 mm stud bolts are flush with the holes in the mount frame of the stern bracket/swivel case assembly. 2) Holding the outboard motor with the hoist, move the stern bracket/swivel case assembly, that are attached to the outboard motor stand, slowly toward the outboard motor. Insert the 12 x 145 mm stud bolts into the mount frame and tighten the two 12 mm self-locking nuts to the specified torque. TORQUE: 83 N . m (8.5 kgf . m, 61 lbf . ft) [1] 12 mm SELF-LOCKING NUT (2) 83 N . m (8.5 kgf . m, 61 lbf . ft) [2] STERN BRACKET/SWIVEL CASE ASSEMBLY 3) Install the lower rubber mount (P. 14-93).

[2] HOIST CHAIN 4) Detach the hoist hooks from the three engine hangers. [3] ENGINE HANGER (2) [1] ENGINE HANGER B 15-12