honda — Power Trim/Tilt Assembly

5) Pass the tube and wires through the hole in the under cover front bracket. [1] UNDER COVER FRONT BRACKET [2] WIRES [3] TUBE Check that the taped ends of the power tilt motor wire and trim angle sensor wire are in alignment with the end of the undercase grommet C. Install the undercase grommet C on the under cover front bracket so they engage securely in the groove of the undercase grommet C. Move the front lock with a hand and check that the wires and tube do not interfere with the front lock. [4] UNDERCASE GROMMET C 6) Connect the trim angle sensor 3P connector and the power tilt motor 2P connector.

[1] POWER TILT MOTOR 2P CONNECTOR [2] TRIM ANGLE SENSOR 3P CONNECTOR Install the power tilt motor 2P connector on the lower side of the connector bracket A and the trim angle sensor 3P connector on the upper side of the connector bracket A. 7) Install the following parts. – Starter cable (P. 18-17) – Remote control cable/grommet (P. 17-5) – Gear case assembly (P. 14-5 and 44) – L./R. engine under covers (P. 4-14) – Engine cover (P. 4-2) [3] CONNECTOR BRACKET A 15-13 [5] HO LE ires and tube must t interfere with the ck lever. not interfere lock lever. [9] t interfere ck lever. [8] TAPED PARTS 11] SPEED SENSOR TUBE A [10] TRIM ANG SENSOR