9) Remove the 15 mm E-ring from the upper cylinder pin. Remove the upper cylinder pin and the piston rod of the power trim/tilt assembly from the swivel case assembly. Check the upper cylinder bushing mounted on the piston rod of the power trim/tilt assembly. If it is damaged, replace with a new one. 10) Remove the upper cylinder bushing. Replace with a new one on assembly. [3] SWIVEL CASE ASSEMBLY [2] UPPER CYLINDER PIN [1] 15 mm E-RING (2) [5] UPPER CYLINDER BUSHING (2) [4] PISTON ROD 11) Remove the two 6 x 20 mm hex. bolts and the two 6 mm washers from the trim angle sensor, and remove the trim angle sensor. [1] TRIM ANGLE SENSOR [3] 6 mm WASHER (2) [2] 6 x 20 mm HEX. BOLT (2) 15-17