honda — Power Trim/Tilt Assembly

12) Remove the tilting bolt cap and loosen the 25 x 2.0 mm self- locking nut or the 7/8-14 UNF self-locking nut. [1] TILTING BOLT CAP 13) Holding the power trim/tilt assembly with the hands, extend the L./R. stern brackets to the right and left and remove the lower cylinder collar and the two 32 mm wave washers. 14) Pull off the wires and tube through the hole in the L. stern bracket and remove the power trim/tilt assembly. Check the lower cylinder bushings mounted on the power trim/tilt assembly for damage. Replace the bushings with the new ones if necessary. [3] 25 x 2.0 mm SELF- LOCKING NUT [2] 7/8-14 UNF SELF- LOCKING NUT 15) Remove the lower cylinder bushings.

Replace the lower cylinder bushings with the new ones on assembly. NOTICE Do not push in the piston rod after removing the power trim/tilt assembly. If the piston rod is pushed down, extend the piston rod fully and hold it in the position. Store the power trim/tilt assembly vertically with the upper cylinder pin installation part facing up after removal. Never store the power trim/tilt assembly by laying it on its side or with the lower cylinder collar installation part facing up. [1] R. STERN BRACKET If it is hard to remove the lower cylinder collar, loosen the 25 x 2.0 mm self-locking nut again. [2] LOWER CYLINDER COLLAR [7] UPPER CYLINDER PIN INSTALLATION PART [6] L.

STERN BRACKET [3] POWER TRIM/TILT ASSEMBLY [5] 32 mm WAVE WASHER (2) [8] LOWER CYLINDER PIN INSTALLATION PART [4] LOWER CYLINDER BUSHING (2) 15-18