16) Remove the 25 x 2.0 mm self-locking nut or 7/8-14 UNF self-locking nut from the tilting shaft. Replace the 25 x 2.0 mm self-locking nut or 7/8-14 UNF self-locking nut with a new one on assembly. 17) Remove the tilting shaft and remove the L./R. stern brackets, two 26 mm wave washers and the swivel case assembly. Check the swivel case bushing that is mounted on the swivel case assembly. Replace the swivel case bushing if it is damaged. 18) Remove the swivel case bushing. Replace the swivel case bushing with a new one on assembly. 19) Remove the 15.54 x 2.26 mm O-ring from the tilting shaft. Replace the O-ring with a new one on assembly. Remove the wire harness clip from the L.
stern bracket. [1] SWIVEL CASE ASSEMBLY [2] 7/8-14 UNF SELF- LOCKING NUT [11] SWIVEL CASE BUSHING [3] TILTING BOLT CAP [10] 26 mm WAVE WASHER (2) [9] 25 x 2.0 mm SELF- LOCKING NUT [4] TILTING SHAFT [5] 15.54 x 2.26 mm O-RING [8] WIRE HARNESS CLIP [6] R. STERN BRACKET [7] L. STERN BRACKET b. INSPECTION [1] TRIM ANGLE SENSOR 3P CONNECTOR • TRIM ANGLE SENSOR Attach the tester leads to the trim angle sensor connector and measure the resistance. 15-19 Resistance between Light green/black and Black 4 – 6 Ω Resistance between Yellow/blue and Black 2.7 – 4.3 kΩ