7) Remove the three grease fittings from the swivel case. [2] SWIVEL CASE 8) Remove the two 10 mm self-locking nuts and the two 10 mm washers, then remove the two thrust receivers. [3] 10 mm SELF- LOCKING NUT (2) [1] GREASE FITTING (3) [4] 10 mm WASHER (2) [5] THRUST RECEIVER (2) 9) Remove the 6 x 14 mm hex. bolt, and remove the detent assisted spring and the detent spring. 10) Using a commercially available 2.5 mm pin driver, drive out the 2.5 x 20 mm spring pin to the position where it does not interfere with the swivel case as shown. Remove the driven-out 2.5 x 20 mm spring pin using the cutting pliers or equivalent tool. Remove the spring pin on the other side in the same manner.
11) Remove the two tilt stoppers and the tilting bracket. Check the tilt arm bushings mounted on the swivel case. Replace them with the new ones if they are damaged. 12) Remove the tilt arm bushings. Replace the tilt arm bushings with the new ones on assembly. 15-24 [2] 2.5 x 20 mm SPRING PIN (2) [4] 2.5 x 20 HEX. B [3] DETENT SPRING [9] SWIVEL CASE [8] TILT ARM BUSHING [2] 2.5 x 20 mm SPRING PIN (2) [1] 2.5 mm PIN DRIVER (Commercially available) mm OLT [5] DETENT ASSISTED SPRING [9] SWIVEL CASE [8] TILT ARM [2] 2.5 x 20 mm SPRING PIN (2) [6] TILTING BRACKET [7] [7] (2) TILT STOPPER (2)