f. SWIVEL CASE ASSEMBLY ASSEMBLY 1) Apply grease to the circumference of the new tilt stopper bushings and install them on the swivel case. 2) Install the two tilt stoppers and the tilting bracket on the swivel case. Install the tilt stopper in the position shown. Check that the projection on the tilting bracket is in the position shown. 3) Drive the 2.5 x 20 mm spring pins into the tilting bracket using a commercially available 2.5 mm pin driver as shown. Check that 1 – 2 mm (0.04 – 0.08 in) of the spring pin end is out of the tilting bracket at the opposite side from the driving side. Do not drive in the spring pins excessively.
The tilt stopper cannot operate properly if the extrusion length of the pin is more than 1 – 2 mm (0.04 – 0.08 in). 4) Apply grease to the cam of the tilting bracket. 5) Apply grease to the detent spring roller. Secure the detent spring and the detent assisted spring with the 6 x 14 mm hex. bolt. 6) Install the two thrust receivers on the swivel case, then install the two 10 mm washers and the two 10 mm self- locking nuts. [2] SWIVEL CASE [3] 10 mm SELF- LOCKING NUT (2) [1] GREASE FITTING (3) Tighten the 10 mm self-locking nuts securely. Apply grease to the sliding surface of the thrust receiver. 7) Set the three grease fittings on the swivel case, and tighten them to the specified torque.
TORQUE: 3 N . m (0.3 kgf . m, 2.2 lbf . ft) [4] 10 mm WASHER (2) [5] THRUST RECEIVER (2) 15-26 [1] [2] PROJECTION 2.5 mm PIN DRIVER (Commercially available) [4] 2.5 x 20 mm SPRING PIN [3] DRIVE-IN (2) DIRECTION 1 – 2 mm [6] (0.04 – 0.08 in) 6 x 14 mm [5] HEX. BOLT [7] DETENT DETENT ASSISTED SPRING SPRING [4] 2.5 x 20 mm SPRING PIN (2) [11] SWIVEL CASE [8] TILTING BRACKET [9] TILT STOPPER [10] TILT ARM (2) BUSHING (2) [4] 2.5 x 20 mm SPRING PIN (2) [8] TILTING BRACKET [9] TILT STOPPER [9] TILT STOPPER 0] TILT ARM BUSHING (2) (2) N E-IN CTI ON